Starlink mini flat mount for rectangular dishy. RV Roof Adaptor. Protective case from ASA plastic.

Perfect solution for your van, motorhome or boat. Our secure case allows you to enjoy the internet on the go without worrying about the safety of your Starlink Mini antenna.

⭐️ This is the best STARLINK MINI roof mount (flat mount) for your camper or car. Why?
- Ease of use. You put the Starlink inside, close the lid. Screw the cover to the base with stainless 4 bolts (included in the kit). Done. No need to glue the Starlink on and worry about it.
- Safety of your Starlink. The cover reliably protects it from precipitation, stones, hail.
- The cover doesn't interfere with the signal passage. Tested by hundreds of buyers.
- Made from ASA plastic resistant to ultraviolet light.
- The mount is made from a solid piece of plastic, ensuring reliability, durability, and convenience.

⭐️ FAIRING
Is an additional part (shown in the second-to-last photo) designed to improve the aerodynamics of the entire mount. If this is relevant for you, feel free to add it to your cart as well.
We include it separately in the set, and it is mounted using the same screws that secure the cover. The fairing can be attached to either side of the mount.
If you plan to use it permanently, you can glue it to the cover. In this case, when removing the cover, the fairing will remain attached to it.


⭐️ Mounting on the roof can be fixed in 4 different ways:
1 - By magnets (on the outside if you have a steel roof)
2 - By suction cups (on the glass or sunroof from inside the car)
3 - Screws (there are holes for M5 screws in the base)
4 - Glue (wide contact surface will allow you to do this)

☝🏻ATTENTION!
This mount is specifically for the STARLINK MINI. Starlink Mini antenna is similar in appearance to Starlink Standard (Gen 3) antenna. But they are different in size.
✅ Starlink Mini - 298.5 mm (11.75 in) x 259 mm (10.2 in)
❌ Standard (Gen 3) - 594 mm(23.4 in) x 383 mm(15.07 in)

The colour of the suction cup attachment will match the colour of the housing, but the suction cup itself will always be black (as shown in the photo).

External dimensions of the mount: 317 x 277 x 45 mm (12.48 x 10.91 x 1.77 in)